PPC Drop Test for Mobile Devices


PPC Drop Test for Mobile Devices

The first test in this comparative study was the drop test. Each tank in the first set was filled with 7000 pounds of water, and lifted with a crane, one at a time, to a height of 15 feet. This height is comparable to that used in the testing of polyethylene drums used for fuel storage. Once the rotomolded tank reached the desired height it was released and allowed to free-fall onto the concrete surface below.  This catastrophic failure and its associated crack propagation appeared to be consistent with the un-zipping characteristic found in linear polyethylene resin grades. On the other hand, the cross linked polyethylene tank did not fail or develop any cracks.

We then filled the exact same Poly Processing Crosslinked Tank, the same tank that had just been dropped, but this time with 11000 pounds of water. That’s over 15 times the weight of an empty tank. We dropped it from the same height, to the same surface with the same results, no damage to the tank

To prove the tank was not damaged and to demonstrate the outstanding robustness of our Crosslinked Polyethylene Tanks, we dropped the same tank for a 3rd time. This time we went as high as the crane would go, 45 feet in the air which is 5 times the height of the tank. It held 11000 pounds of water which is 15 times the weight of the empty tank.  Again no damage to the tank after the 3rd drop

File Name: PPC Drop Test for Mobile Devices.mp4
Category: Salesperson Bag
File Size: 16.31 MB
File Type: application/octet-stream
Hits: 1730 Hits
Created User: Marshall Lampson
Created Date: 02-06-2018
Last Updated Date: 02-06-2018